There's loads of steering wheels out there, but the availability of boss's and adaptors for our slightly strange 3 bolt Sud steering column are slim pickings.
I'd got a lovely Momo wheel for Pat's sud, but no boss, but looking at it, i though how hard can it be?
I had an old Mountney wheel with a Sud boss already attached, so i removed that, and ground the profile off the front face so it was flat (if my lathe was up and running i'd work around that as a locater)
Pillar drill, 6mm threads tapped in, an voila, one Momo to Sud adapter plate. The plate mounts in descretely from the back, then the wheel from the front. I spaced the wheel pcd so that it is multi positional for options on alignment, but also in a few position it completely cloaks the plate mounts too just for smartness.
I left the centre of the plate whole, and a nice alfa logo would look the bee's knee's in there, seeing as we don't need the luxury of a horn, this was an easy decision
Finally, not knowing Pats thoughts on interior decorating, rather than paint it, powder coat it, or any covering whatsoever, i assumed safely that i can't go far wrong with a good buff!
So here it is
