Page 1 of 1
Heater flap
Posted: Sun Oct 28, 2018 2:32 pm
by alfadave
The heater flap on mine has 2 studs on it to pick up link rods.
But the lower link rod on mine is missing.
Should be ready to put the dash back in soon.....but the link rod is needed first!
Re: Heater flap
Posted: Sun Oct 28, 2018 10:47 pm
by alfasuddriver
Helpful photos
Re: Heater flap
Posted: Sun Oct 28, 2018 11:28 pm
by alfadave
Thanks Richard
I need the link rod from the lower stud (RH on your photo)
Re: Heater flap
Posted: Mon Oct 29, 2018 7:28 pm
by Alfastrut
This?
Re: Heater flap
Posted: Mon Oct 29, 2018 7:35 pm
by alfadave
Yes!
The one link rod I have is 110mm o/all length.
No second one is missing....so not sure of its length.
Of course they are adjustable,so could vary slightly
Re: Heater flap
Posted: Mon Oct 29, 2018 7:46 pm
by Alfastrut
Hi dave
There is only one. It attaches to the nearest connection to the hinge and then to the bottom control side. Perhaps some other members could confirm this?
Re: Heater flap
Posted: Thu Nov 01, 2018 8:36 pm
by alfadave
Dead right just one link.
When I saw 2 brackets on the flap, and 2 studs on the heater contol.....I presumed there were 2 links.
Re: Heater flap
Posted: Thu Nov 01, 2018 8:48 pm
by Alfastrut
I would have took a pic but the stereo was in the way
Re: Heater flap
Posted: Thu Nov 01, 2018 8:53 pm
by alfadave
I never fit a stereo....I just listen to the music from the engine!
Re: Heater flap
Posted: Thu Nov 01, 2018 9:00 pm
by Alfastrut
I didn't say it was working