Hmm... followed the Haynes manual procedure says and it ends with undo this and that and then ‘juggle out the wiper motor and linkage assembly together’.....
Any tips on how to juggle it out of a rhd Sprint? Mine seems reluctant to come out, one or other of the wiper spindles seem to foul the scuttle...?
Wiper motor retrieval
Re: Wiper motor retrieval
Did that job recently.
Impossible to describe......just keep juggling carefully!
Dave
Impossible to describe......just keep juggling carefully!
Dave
Re: Wiper motor retrieval
As Haynes say.... refitting is just a reversal of removal. FFS!!!!!
Si puo diventare Alfista
Si puo anche nascere come Alfista
Ma si muore sempre come Alfista
Si puo anche nascere come Alfista
Ma si muore sempre come Alfista
Re: Wiper motor retrieval
Damn, planned on doing this myself this weekend. Thought it would be easy.
My wipers are super slow so thinking a bit of cleaning up would help.
If you come up with the magic juggle let me know!
My wipers are super slow so thinking a bit of cleaning up would help.
If you come up with the magic juggle let me know!
Sprint 1.7QV 1989
-
- Posts: 205
- Joined: Thu Apr 16, 2015 6:30 am
Re: Wiper motor retrieval
Thanks for the advice, I’ll keep “juggling” ........but now worried I won’t be able to perfect the “reverse juggle” and be left with no wipers and 2 holes in the front scuttle for eternity
Brussels, it’s super simple up to the “juggling” point.
Brussels, it’s super simple up to the “juggling” point.
Re: Wiper motor retrieval
With my racer I only had half the wipers and it came out easily. So then I wondered about how to get a full set in, but it was quite easy `juggling' as you can fully see what your up too. Good luck.
Re: Wiper motor retrieval
the last time i did that amount of juggling and jiggling, it got me in trouble
-
- Posts: 205
- Joined: Thu Apr 16, 2015 6:30 am
Re: Wiper motor retrieval
Thanks, although certainly hoping it’s not going to come to that
-
- Posts: 205
- Joined: Thu Apr 16, 2015 6:30 am
Re: Wiper motor retrieval
It’s out! It wasn’t that bad in the end. The knack seemed to be to twist the motor upwards (so spindles roll back towards the dashboard) and then bring the drivers side spindle our first, just scrapping over the relay and fuse box.
So once refurbished, just hope I can get it back in again
So once refurbished, just hope I can get it back in again