I've had some made by my local signwriter, he said the material is impossible to replicate however what he's come up with is more than acceptable and at a reasonable price, if I could work out how to upload a picture I'd be able to show you

Hello, has anyone got any new rear quarter badges / stickers for an S2 ti? Or know of someone who's successfully replicated them?

Hello, have you got any pics of this sill panel ? I've got one for my Sud though could do with the other side before it goes for welding.

I'll be doing it on my two post ramp, hopefully that should ease things, pallet with a scrap tyre on the floor, drop engine onto pallet, lift ramp, sounds easy!

Time for the front calipers to be rebuilt on our Ti, are all front calipers the same ? There's a kit listed on ebay that says they are for Lucas calipers only ? Without digging the car out I wouldn't know if they are or not, any easy way of finding out ? Or has anyone used a kit they can recommend ?...

OK, I'm sure it's been asked before, what's the easiest method of doing a Sud clutch? Can the engine be supported from above and the box dropped from underneath?
Would like to leave the engine in place as one of the manifold bolts has been wound in at an odd angle so I'd rather not disturb if poss

Have you got a picture ? ( and a price posted to Ipswich )

thanks

Hello, both would be a bonus though from memory one side is worse than the other. The car isn't stored at home so I can't pop out and check, what have you got ? I could do with sills too, mainly the lips are crusty, I think these will just have to be fabricated unless anyone has a pair gathering dust

Need to replace rear arches on our Sud ti, with arch repair sections hard to come by has anyone found a more easily available arch repair panel that has similar profiles to an Alfasud?

Good morning, great work though I bought a tank from Peter the Alfasud Spares man which is in my 5M. Otherwise I'd be first in the queue for a new tank. I'm going to keep the old one as despite being old it could still be saved.

I think £300 is a bit excessive, shame no one has found one from another car that fits in the space under the car. I'll make some calls to the obvious alfasud breakers tomorrow

Good evening, has anyone got a decent Sud fuel tank they don't need or know where to source one? Mine is 40 years old and its pretty knackered. I've tried various methods of repair though I think it's time for a new one.

I had the same issue on our 5M, I ended up using ones from a 51 plate Clio (a part ex I was scrapping) The car was a three door, I ended up taking the ones from another scrapper and cut off the excess so that all my doors had the same seal. I had to source decent front seat belts too as mine were kn...

So a little update, my 5M has been through a rather large rebuild, I checked the coil wiring and it seems the coil wires we not wired correctly. So I swapped them so that now the feed from the distributor goes to the negative side of the coil, the positive to the ignition switch. Took for a run toda...

Any recommendations on electronic ignition for my ducellier equipped 5M?

Ok, so my new accuspark coil ( non ballast ) still over heats. In answer to one question, it's not bolted to the body of the car currently, will this affect it ? I'll be getting the car out again tomorrow to test, I'll bolt it to the body by the brake reservoir where it should live. I've replaced th...

I've just ordered an Accuspark high performance ignition coil, no mention in the listing if it had a ballast resistor or not, have I ordered the correct one for my Sud ? Do I need one with a ballast resistor or without ?

Hello, Can anyone shed any light? The ignition coil on my 5M seems to get far too hot, after half an hour of tick over the car will cut out, the coil is almost unbearable to hold, at the same time the spark at the plugs is almost non existent. Is this just an over age coil are are there ignition iss...

Hello, has anyone got a series one front grill they dont need ? My 5M is missing one , some decent seats would be a bonus too

thanks
Jerran

Can anyone suggest a place that can supply a gasket set for the Solex 32 dis carb on my Sud 5M before I trawl through Google? Also will need a throttle cable

Thanks

Good morning, I'm in the process of having our 5M slightly restored, the car was complete when bought though I'll need some parts. Before buying off ebay I thought I'd try here first. I need Passenger front wing Front & rear seats ( mine are sun bleached and worn ) Door cards Dashboard ( mine is use...